even after locking and leaving the car! Once the “Power Save Mode“ is active the remote output and therefore the connected amplifiers will be turned off. Please note that in many up-to-date cars with “CAN” or any other internal bus structures it may happen that the radio remains “invisibly” turned on for up to 45 min. It allows to significantly reduce the power consumption of the PP 86DSP and potentially connected amplifiers once there’s no input signal present for more than 60 seconds. The Power Save Mode is incorporated in the basic setup. Switching between analog and digital inputs. Alternatively you can use an optional remote control for manual This feature can be deactivated in the DSP PC-Tool software. Switching from analog input to the digital input is done automatically as soon as a signal is detected on the Optical Input. If the supply voltage drops below 10.5 Volts for more than five seconds the amplifier goes to “Protect mode” (Status LED lights up red) in order to avoid any further discharge of the car’s battery. The switched power supply of the MATCH PP 86DSP assures a constant internal supply voltage even if the battery’s voltage drops to 6 Volts during engine crank. The new ADEP circuit (Advanced Diagnostics Error Protection) avoids all these problems without loading the speaker outputs of the OE radio during high volumes unnecessarily. ![]() fader function) are often the result – but not with the PP 86DSP. If an common amplifier will be hooked up failure messages and loss of specific features (e.g. The latest generation of OE car radios incorporates sophisticated possibilities of diagnosing the connected speakers. By varying the internal supply voltage depending on the amplifier’s amplitude of the input signals, idle losses are significantly reduced and overall efficiency is close to maximum at any time. The result is an unsurpassed efficiency which easily outperforms any conventional Class D amplifier. The PP 86DSP combines the advantages of a Class H technology with the principle of a class D amplifier. Easy installation via included Plug & Play connection cable.Dual mono RCA output for the connection of an external amplifier e.g.Auto Remote switch for activating / deactivating the automatic turn-on feature via the highlevel inputs.Optical input in SPDIF format with sampling rates between 12 and 96 kHz.Start-stop capable down to 6 Volts supply voltage.Adjustable input sensitivity from 5 to 11 Volts.Smart 6-channel highlevel input with ADEP.2 circuit (Advanced Diagnostics Error Protection, 2nd generation). ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |